Siemens SIMOREG DC Master 6RA7018-6DS22 - Page 278

Function diagrams 02.00
8-98 SIEMENS AG 6RX1700-0AD76
SIMOREG DC Master Operating Instructions
Sheet Z110 Data exchange with a technology board (TB) or
the 1
st
communications board (CB)
.04 .01 .03 .02 .06 .05 .07 .08 .10 .09 .14 .11 .13 .12 .16 .15
87564321
- Z110 -
U734 (0)
K K K K K
1s
B3030
B3031
K K K K K K K K K K K
K3001
K3002 K3003 K3004 K3005 K3006 K3007 K3008 K3009
K3010 K3011 K3012
K3013 K3014 K3015
K3016
B3100
Bit 0 ... Bit 15
B3200 B3300
B3400
B3500 B3600 B3700 B3800 B3900
B3115 B3215 B3315 B3415 B3515 B3615 B3715 B3815 B3915
U722.01 (0 ms)
CB parameters 1 to 10 CB or TB diagnosis CB parameter 11
1 = "Fault F082"
Initialize link to supplementary boards
Parameters for the 1
st
CB board
Message
monitoring time
Message monitoring for received process data:
Valid for the following configurations: - CB only - TB only - CB after TB (CB in slot G) - 2 CBs (for CB with the lower slot letter)
Bit 10 must be set in word 1 of the receive data to ensure that the process data are accepted as valid data. Control word 1 must therefore be transferred as the first PZD word.
(fault value 10)
Display parameter job (PKW) from CB Display parameter response (PKW) to CB Display parameter job (PKW) from TB Display parameter response (PKW) to TB
Receive data
Word 1
Word 2 Word 3 Word 4 Word 5 Word 6 Word 7 Word 8
Word 9
Word 10
Transmit data
Fault message trigger
1 = "Telegram monitoring timeout"
Word 11
Word 12 Word 13 Word 14 Word 15 Word 16
Word 1
Word 2 Word 3 Word 4 Word 5 Word 6 Word 7 Word 8
Word 9
Word 10 Word 11 Word 12 Word 13 Word 14 Word 15 Word 16
every 16 bits
Data exchange with a technology board (TB) or the 1st communications board (CB)
from supplementary board
to supplementary board
n733.01 to .16
n735.01 to .16
Bus address Enable parameterization
U711-U720 Index.01 n732 Index.01-.32 n738 Index.01-.04 n739 Index.01-.04 U721 Index.01-.05 P918 Index.01 n738 Index.09-.12 n739 Index.09-.12 U710 Index.01 P927