Siemens SIMOREG DC Master 6RA7018-6DS22 - Page 279

02.00 Function diagrams
SIEMENS AG 6RX1700-0AD76 8-99
SIMOREG DC Master Operating Instructions
Sheet Z111 Data exchange with the 2
nd
communications board (CB)
.04 .01 .03 .02 .06 .05 .07 .08 .10 .09 .14 .11 .13 .12 .16 .15
87564321
- Z111 -
K K K K K
1s
B8030
B8031
K K K K K K K K K K K
Bit 0 ... Bit 15
U722.02 (0 ms)
U736 (0)
K8001 K8002 K8003 K8004 K8005 K8006 K8007 K8008 K8009 K8010 K8011 K8012 K8013 K8014 K8015 K8016
B8100 B8200 B8300 B8400 B8500 B8600 B8700 B8800 B8900
B8115 B8215 B8315 B8415 B8515 B8615 B8715 B8815 B8915
Parameters for the 2nd CB board
Data exchange with the 2nd communications board (CB)
U710 Index.02
U711-U720 Index.02
n732 Index.33-.64
n738 Index.05-.08 n739 Index.05-.08 P927 U721 Index.06-.10 P918 Index.02
1 = "Fault F082"
Message
monitoring time
Message monitoring for received process data:
Valid for the following configurations: - 2 CBs (for CB with the higher slot letter)
Bit 10 must be set in word 1 of the receive data to ensure that the process data are accepted as valid data. Control word 1 must therefore be transferred as the first PZD word.
(fault value 10)
Receive data
Word 1
Word 2 Word 3 Word 4 Word 5 Word 6 Word 7 Word 8
Word 9
Word 10
Transmit data
Fault message trigger
1 = "Telegram monitoring timeout"
Word 11
Word 12 Word 13 Word 14 Word 15 Word 16
Word 1
Word 2 Word 3 Word 4 Word 5 Word 6 Word 7 Word 8
Word 9
Word 10
Word 11
Word 12 Word 13 Word 14 Word 15 Word 16
every 16 bits
from supplementary board
to supplementary board
n733.17 to .32
n735.17 to .32
CB parameters 1 to 10 CB or TB diagnosis CB parameter 11 Initialize link to supplementary boards Display parameter job (PKW) from CB Display parameter response (PKW) to CB Bus address Enable parameterization