Unrestricted 69 A5E43486667A_AB
Immunity to Interference
The motors in principle fulfill the requirements of interference
immunity in conformity with the standards applied in their location. If the
motors with integrated sensors (e.g. PTC thermistors) are used, the
operating company must ensure sufficient interference immunity by selecting
a suitable sensor signal lead (Possibly with shielding, connected in the same
way as the motor feeder cable) and a suitable evaluation unit.
Assembly motor and lifting. 6
Before any handling, make sure you have your personal safety equipment
such as shoes, gloves, girdle and lenses because if these preventive
measures are not taken, physical damage may occur.
CAUTION: Although the motors are robust in construction, these must
be handled with care. Dropping or jarring a motor can seriously damage its
components. When lifting, use a device with sufficient load capacity.
WARNING. Instructions for lifting.
1.- Before starting any activity of lifting, make sure the eye bolt or screw are
firmly held and fully in contact with the surface of the motor.
Right Incorrect
2.- Motors must not be lifted by the shaft, but by the eyebolt, which has
been designed to lift only the motor.
3.- It is forbidden to move loads over the worker height, loads should be
transported closed to the floor.
4. - Before lifting check stability of load.
To Next Page
Loading...
Need help?
General