Siemens SINAMICS G120X - Page 13

3 Commissioning using IOP-2
G120X commissioning guide for permanent magnet motors PMSM
Entry-ID: 109780815, V1.0, 07/2020
13
© Siemens AG
2020 All rights reserved
8
If the drive is connected to fieldbus go to
Fieldbus Setup and set appropriate
communication parameters if necessary.
9
Skip from the Advanced Startup menu by
pressing Ok or ESC key for 2s and
confirm Save Settings.
10
Go to Parameters menu
11
In the Parameter Filter select option
Expert
12
Then go to Search by number and type
00352 confirmed by OK to display
parameter p352. Enter correct motor
cable resistance.