2.2 Visual inspection
The visual inspection is performed to ensure that the equipment complies with the order
specifications. The tests are carried out with the drive in a no-voltage condition.
The visual inspection together with the customer – or with the company accepting the
equipment – is carried out with the drive installed and labeled. Each test step is documented in
the acceptance report with the specific results of the step.
The visual inspection is part of the function test (F72, F73).
Visual inspection Order codes
Without the
customer
present
With the cus‐
tomer
present
● Rating plate
● Housing degree of protection
● Electrical cabinet components
● Cable installation
● Cable markings
● Setting values of circuit breakers, if used
● Dimensions
-
F03
See also
Visual inspection (Page 16)
The following additional tests are available for low voltage drives in the marine version.
Visual inspection Order codes
Without the
customer
present
With the cus‐
tomer
present
● Derating diagram
● List of the miniature circuit breakers and circuit breakers
● Marine version
-
F03
See also
Visual inspection (Page 16)
General scope of services
2.2 Visual inspection
SINAMICS G150 6SL37102G E11 F72 F76 F79 L45 L50 L57 L68 M54 U11
12 Reference Manual Rev.201902141443 LV Umrichter
To Next Page
Loading...
