Preface
© Siemens AG, 2004. All rights reserved
vi EMC Installation Guideline – Planning Guide (EMV) – 03.2004 Edition
These guidelines also describe the necessary measures according to the
European Union (EU) directives for compliance with the EMC law or the EMC
guidelines.
In installation locations with extremely high interference levels, malfunctions can be
caused despite compliance with these EMC Guidelines, although it is very unlikely.
What prior knowledge is required?
Apart from these EMC Guidelines, international and country-specific safety
regulations continue to apply.
Good knowledge of the relevant standards and EU regulations is necessary, so
that the safety concerns are not impaired when implementing these EMC
Guidelines. The implementation of these EMC Guidelines must be performed by
qualified personnel.
Qualified personnel
All persons who are entrusted with the installation, assembly, commissioning and
operation of the product and who possess the necessary qualifications are to be
considered to be qualified personnel.
The authorization to connect circuits and devices in accordance with the approved
standards of electrical engineering, to bring them into operation and to remove
them from operation applies as a particular qualification.
Hotline
If you have any questions, please get in touch via our hotline:
A&D Technical Support Phone.: ++49-(0)180-5050-222
Fax: ++49-(0)180-5050-223
Email: adsupport@siemens.com
If you have any questions about the documentation (suggestions, corrections, etc.),
please send a fax or e-mail to:
Fax: ++49-(0)9131-98-2176
Email: motioncontrol.docu@erlf.siemens.de
Fax form: See the reply form at the end of the document.
Internet addresses
Motion Control Systems: http://www.siemens.com/motioncontrol
Finding your way around
To assist you in your orientation, you have a table of contents and an index.
To Next Page
Loading...
