Need help?Do you have a question about the Siemens SINAMICS G120 CU240E-2 and is the answer not in the manual?
General| Product type designation | SINAMICS G120 CU240E-2 |
|---|---|
| Digital inputs | 6 |
| Analog inputs | 2 |
| Protection class | IP20 |
| Input voltage range | 3AC 380V to 480V ±10% |
| Output voltage range | 0V to input voltage |
| Rated current | Refer to the specific CU240E-2 model (e.g., CU240E-2 DP, CU240E-2 PN) |
| Output current range | Refer to the specific CU240E-2 model (e.g., CU240E-2 DP, CU240E-2 PN) |
| Power rating | Refer to the specific CU240E-2 model (e.g., CU240E-2 DP, CU240E-2 PN) |
| Control type | V/f, vector control |
| Communication interfaces | PROFIBUS |
| Operating temperature range | -10 ... 50 °C (depending on the specific model and derating) |
| Relative humidity | 5% to 95%, non-condensing |
| Digital outputs | 2 relay outputs |
| Altitude | Up to 1000m without derating |
Provides guidelines for safe, reliable, and disturbance-free inverter installation.
Covers using factory settings for basic applications and their prerequisites.
Details the steps for commissioning the inverter using the STARTER software tool.
Covers connecting to PROFIBUS DP, recommended connectors, and configuring communication.
Covers integrating inverters into bus systems via the RS485 interface.
Compares V/f control and vector control techniques for induction motors.
Covers protective functions against overtemperature, overcurrent, and DC link voltage.
Describes the commissioning of the STO safety function via fail-safe digital inputs.
Covers fault signals, fault buffer, fault history, and fault acknowledgement.
Provides a comprehensive list of faults, their causes, and recommended remedies.
To Next Page