Siemens SINAMICS G120 CU240E-2 - Guide through this Manual

Introduction
1.2 Guide through this manual
Inverter with CU240B-2 and CU240E-2 Control Units
12 Operating Instructions, 07/2010, FW 4.3.2, A5E02299792B AA
1.2 Guide through this manual
In this manual, you will find background information on your inverter, as well as a full
description of the commissioning procedure:
①
Should you be unfamiliar with assigning
parameters to the inverter, background
information can be found here:
 Adapting the inverter in line with the
appli
cation (Page 15)
 Frequently required parameters (Page 18)
 Extended scope for adaptation (Page 20)


,QYHUWHUFRPSRQHQWV
HJUHDFWRUVILOWHUVRSHUDWRUSDQHO
%DVLFV
,QYHUWHUSDUDPHWHUV
②
Information on the inverter hardware can be
found here:
 Modularity of the converter system
(Page 25)
All information relating to the commissioning
of your inverter is located in the following
chapters:
③
 Procedure for installing the frequency
inverter (Page 31)
④
 Commissioning (Page 55)
 Configuring the terminal block (Page 93)
 Connection to a fieldbus (Page 103)



,QVWDOODWLRQ
,QVWDOOLQJDQGZLULQJWKHLQYHUWHU
$GDSWLQJWRDSSOLFDWLRQ
%DVLFFRPPLVVLRQLQJFRQILJXULQJLQWHUIDFHV
VHWWLQJIXQFWLRQV
'DWDEDFNXS
2QWKHKDUGGLVNRI\RXU3&3*RURQWKH
PHPRU\FDUG
6WDUWRIFRPPLVVLRQLQJ
(QGRIFRPPLVVLRQLQJ
⑤
 Back-up the settings and transfer
(Page 86)
⑥
Information regarding the maintenance and
diagnostics of your inverter is located in the
following chapters:
 Service and maintenance (Page 237)
 Alarms, faults and system messages
(Page 243)


7HF KQLFDOGDWD
0DLQWHQDQFHDQGGLDJQRVWLF
5HSODFLQJFRPSRQHQWVGLVSOD\VDODUPV
IDXOWV
⑦
The most important technical data for your
inverter is located in this chapter:
 Technical data (Page 261)