Siemens SINUMERIK 808D Operating Guide

Operating and Programming — Milling Page 54 808D
Simulate
Program
s
SEQUENCE
Step 2
If the control is not
in the correct mode,
a message will be
displayed at the
bottom of the
screen.
If this message is displayed at the
bottom of the screen, press the
“AUTO” mode key on the MCP.
Step 3
Press the “Simu.” SK on the PPU.
Press the “CYCLE START” key
on the MCP.
Press the “Edit” SK on the PPU to
return to the program.
End

Siemens SINUMERIK 808D Specifications

General

Brand	Siemens
Model	SINUMERIK 808D
Category	Control Unit
Language	English