Siemens SINUMERIK 808D

© Siemens AG 2017. All rights reserved
01/2017
1
SINUMERIK
SINUMERIK 808D, SINUMERIK 808D ADVANCED
Service Manual
Legal information
Warning notice system
This manual contains notices you have to observe in order to ensure your personal safety, as well as to prevent damage to property. The
notices referring to your personal safety are highlighted in the manual by a safety alert symbol, notices referring only to property damage
have no safety alert symbol. These notices shown below are graded according to the degree of danger.
DANGER
indicates that death or severe personal injury will result if proper precautions are not taken.
WARNING
indicates that death or severe personal injury may result if proper precautions are not taken.
CAUTION
indicates that minor personal injury can result if proper precautions are not taken.
NOTICE
indicates that property damage can result if proper precautions are not taken.
If more than one degree of danger is present, the warning notice representing the highest degree of danger will be used. A notice warning of
injury to persons with a safety alert symbol may also include a warning relating to property damage.
Qualified Personnel
The product/system described in this documentation may be operated only by
personnel qualified
for the specific task in accordance with
the relevant documentation, in particular its warning notices and safety instructions. Qualified personnel are those who, based on their
training and experience, are capable of identifying risks and avoiding potential hazards when working with these products/systems.
Proper use of Siemens products
Note the following:
WARNING
Siemens products may only be used for the applications described in the catalog and in the relevant technical documentation. If products
and components from other manufacturers are used, these must be recommended or approved by Siemens. Proper transport, storage,
installation, assembly, commissioning, operation and maintenance are required to ensure that the products operate safely and without any
problems. The permissible ambient conditions must be complied with. The information in the relevant documentation must be observed.

Siemens SINUMERIK 808D Specifications

General

Brand	Siemens
Model	SINUMERIK 808D
Category	Control Unit
Language	English

Summary

Legal Information

Warning Notice System

Explains the grading of warnings for safety and property damage.

Personnel and Product Usage Guidance

Defines qualified personnel and proper use guidelines for Siemens products.

Preface

Product and Documentation Overview

Lists applicable products and documentation components with their target audiences.

Technical Support and Resources

Provides contact details, links to MDM, and EC declaration information.

Safety Instructions

Fundamental Safety Instructions

Provides essential safety guidelines and principles for operating the equipment.

General Safety Instructions

Outlines general safety rules, emphasizing danger to life from live parts and energy sources.

Service Case Overview

HardwareSoftware Faults

Details service cases related to hardware and software malfunctions.

PLC Alarms

Covers service cases associated with Programmable Logic Controller (PLC) alarms.

NC Program Alarms

Addresses service cases related to Numerical Control (NC) program errors.

Service cases of the hardwaresoftware faults

System Startup and Interface Faults

Covers issues like system startup failures, PPU/HMI faults, and MCP connection problems.

Axis, Spindle, and Drive Faults

Details faults related to spindle, encoder, handwheel, axis movement, and drives.

System Integrity and Configuration Issues

Includes system crashes, hardware limits, drive alarms, and security/configuration problems.

Service cases of the PLC alarms

General PLC Alarms

Lists and describes general PLC alarms including their causes and remedies.

Specific Milling and Turning Alarms

Details PLC alarms specific to milling and turning operations, including their causes and remedies.

Service cases of the NC program alarms

ISO Mode and Chuck Function Alarms

Addresses issues with ISO mode, G81 deactivation, and M10/M11 chuck functions.

Thread Cutting and Zero Offset Issues

Covers thread cutting interruptions and problems with zero offsets in ISO mode.

General NC program alarms