Need help?Do you have a question about the Siemens SINUMERIK 840C and is the answer not in the manual?
General| Brand | Siemens |
|---|---|
| Model | SINUMERIK 840C |
| Category | Control Unit |
| Language | English |
Details different methods for tool and workpiece measurement, considering flexibility, accuracy, and duration.
Classifies and describes different types of touch trigger probes based on deflection directions.
Explains how to calibrate probes and enter data into the TOA memory for turning machines.
Details the fundamental principles of probe signal evaluation and in-process measurement.
Defines tolerance parameters and their impact on machining accuracy and error handling.
Describes methods for logging measurement results using a logging module or CP315.
Lists and explains R parameters utilized in measuring cycles for various functions.
Details the R10 parameter for tool offset memory and ZO determination.
Describes R11 for suppressing dimensional deviations and its effect on calculations.
Defines R22 for specifying probe type and number for measurement.
Explains how R23 selects the measurement variant for various cycles.
Explains tool measurement cycles L972 and L982, covering calibration and measurement.
Covers workpiece probe calibration using L973 for different measurement variants.
Details L974 for various workpiece measurements like 1-point, 2-point, and multi-point.
Provides parameter recommendations for reliable program execution with L973 and L974.
Details workpiece probe calibration using L976 for various surfaces and holes.
Details L977 for measuring holes, shafts, slots, and ZO determination in paraxial mode.
Details L979 for measurements at random angles, covering holes, shafts, slots, and webs.
Details L978 for surface/angle/ZO determination with differential measurement.
Explains how to measure tool lengths and store them in offset memory using JOG mode.
Covers determining workpiece zero offsets using a workpiece probe in JOG mode.
Provides an overview of automatic workpiece measurement in JOG mode.
Guides on setting parameters for workpiece measurement and probe calibration.
Presents various workpiece measurement variants like hole, shaft, slot, web, and surface.
Lists alarms related to measuring cycles and their cancellation methods.
Provides additional details on measuring cycle alarms and their texts.
Offers detailed explanations and remedies for specific alarm numbers.
Provides an overview of transfer parameters for various measuring cycles.
Shows how measurement results are displayed for different cycles.
Details the result parameters (R-numbers) for various measuring cycles.
To Next Page