Operating and Programming — Milling Page 66 808D
Program
Restart
s
SEQUENCE
Press the “Back” SK on the PPU.
The feedrate override must always be set to 0%!
Make sure the correct tool is selected before continuing!
Press the “CYCLE START” key on the
MCP to execute the program.
Press the “CYCLE START” key on the MCP to execute
the program.
Turn the feedrate override on the MCP gradually to the required value.
Alarm 010208 is shown at the top prompting to press the “CYCLE
START” key to continue the program.
To Next Page
Loading...
Need help?
General
