NCK alarms
11/2006 Overview of Alarms
2-31
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
4011 Channel %1 invalid identifier used in machine data %2[%3]
Parameters: %1 = Channel number
%2 = String: MD identifier
%3 = Index: MD array
Definitions: When defining names in the channel-specific tables for geometry axes and channel axes, one of the
following syntax rules for the identifier to be entered has been violated:
- The identifier must be an NC address letter (A, B, C, I, J, K, U, V, W, X, Y, Z), possibly with a
numerical extension (840D: 1-99, FM-NC: 1-9).
- The identifier must begin with 2 arbitrary capital letters but not with $ (reserved for system variable).
- The identifier must not be a keyword of the NC language (e.g. POSA).
Reaction: NC not ready.
Mode group not ready, also effective for single axes
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: Please inform the authorized personnel/service department. Enter the identifier for user-defined
names with correct syntax in the displayed MD
- Geometry axes: 20060 AXCONF_GEOAX_NAME_TAB
- Channel axes: 10000 AXCONF_MACHAX_NAME_TAB
Program
Continuation:
Switch control OFF - ON.
4012 Invalid identifier used in machine data %1[%2]
Parameters: %1 = String: MD identifier
%2 = Index: MD array
Definitions: The selected identifier is invalid. Valid identifiers are:
- AX1 - AXn: Machine axis identifiers
- N1AX1 - NnAXm: Link axis identifiers (NCU + machine axis), only occurs with 'NCU link' expansion
level!
- C1S1 - CnSm: Container axis identifiers (container + container location). Only occurs with 'axis
container' expansion level!
Reaction: NC not ready.
Channel not ready.
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: Use the correct identifier.
Program
Continuation:
Switch control OFF - ON.
To Next Page
Loading...
Need help?
General
