Siemens SINUMERIK 880 GA2 User Manual

User's Guide 08.96 Edition
User Documentation
SINUMERIK 840/840C
SINUMERIK 850
SINUMERIK 880/880 GA2
Measuring Cycles Version 20 and higher

Siemens SINUMERIK 880 GA2 Specifications

General

Brand	Siemens
Model	SINUMERIK 880 GA2
Category	Control Unit
Language	English

Summary

SINUMERIK Measuring Cycles User's Guide

1 Introduction

1.7 Tolerance parameters (R33, R34, R36, R37, R40/R41)

2 Defining Parameters

2.7 R23 Measurement variant

4 Measuring Cycles for Turning Machines

4.1 L972/L982 Tool measurement

Details functions for calibrating and measuring tool lengths and geometry.

4.2 L973 Calibrating the workpiece probe

Explains calibration of workpiece probes in holes or on surfaces.

4.3 L974 Workpiece measurement

Describes measurement of workpiece dimensions like diameter, points, and angles.

5 Measuring Cycles for Milling Machines and Machining Centres

5.1 L976 Calibrating the workpiece probe

Details calibration of workpiece probes in reference holes and on surfaces.

5.2 L977 Workpiece measurement hole/shaft/slots/ZO determination (paraxial)

Measures dimensions and ZO for holes, shafts, slots, and webs paraxially.

5.3 L979 Workpiece measurement hole/shaft/slot/web/ZO determination (at random angles)

Measures features at random angles using 3 or 4 points.

5.4 L978 Workpiece measurement surface/angle/ZO determination (with and without differential measurement)

Determines surface, angle, and ZO with or without differential measurement.

7 Measuring in JOG Mode (SINUMERIK 880/880 GA2)

7.1 Tool measurement

Measures tool lengths and stores them in offset memory without prior data entry.

7.2 Workpiece measurement

Determines workpiece zero offsets using a probe and loads them into zero offset memories.

8 Automatic Workpiece Measurement in JOG Mode (SINUMERIK 840 SW2)

8.1 General

8.2 Setting the parameters for workpiece measurement and calibration

8.4 Workpiece measurement