Siemens SINUMERIK 880 GA2

01.93 11 Abbreviations
11 Abbreviations
AV Average value
AVmem Average value memory
HSS Hole/Shaft/Slot
EV Empirical value
EVmem Empirical value memory
M version Milling machine control
MDC Machine data for cycles (Cycle machine data)
NC MD NC machine data
OGM Operator guidance macro
SDC Setting data for cycles (Cycle setting data)
SW Software version
T version Turning machine control
UMS User memory submodule
END OF SECTION
©
Siemens AG 1990 All Rights Reserved 6FC5197- AB70 11–1
SINUMERIK 840/850/880 (BN)