Siemens SINUMERIK 880 GA2

01.93 9 Alarms
9.3 Alarm description
9.3 Alarm description
4000
Cancel alarm
Explanation:
Remedy:
Alarm line must be cleared to enable further alarms to be displayed by
the measuring cycles.
Press acknowledgement key
4001
Check MDC 0/1
Explanation: Only on installation
4002
Check MDC 2/3
Explanation: Only on installation
4003
Check MDC 1000 to 1019
Explanation: Only on installation
4004
Load MDC inhibited
Explanation: Only on installation with L898/L969
Set MD 5012 bit 2 to ”0”
4005
MDC area exceeded
Explanation: Only on installation
4006
NC type or NC SW-Version wrong
Explanation:
Remedy:
NC type or NC software version wrong
Check MD 157
© Siemens AG 1990 All Rights Reserved 6FC5197- AB70 9–7
SINUMERIK 840/850/880 (BN)