Siemens SINUMERIK 810D

Overview of Alarms 11/2006
NCK alarms
2-588
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
62922 Channel %1 block %2: Output program not specified
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions:
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: --
Program
Continuation:
Clear alarm with the RESET key. Restart part program
62923 Channel %1 block %2: Starting point not specified
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions:
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: --
Program
Continuation:
Clear alarm with the RESET key. Restart part program
62924 Channel %1 block %2: Too many elements in the contour
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions:
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: --
Program
Continuation:
Clear alarm with the RESET key. Restart part program
62925 Channel %1 block %2: Radius specified together with center point
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions:
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: --
Program
Continuation:
Clear alarm with the RESET key. Restart part program