Siemens SINUMERIK 810D

NCK alarms
11/2006 Overview of Alarms
2-591
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
63000 Channel %1 block %2:
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: --
Reaction: Alarm display.
Remedy: --
Program
Continuation:
Clear alarm with the Delete key or NC START.
65000 Channel %1 block %2:
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: References: The current alarm text, the error description and the remedial measures for the user cycle
alarms can be found in the Programming Guide of the machine manufacturer.
Reaction: NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Refer to the manual on user cycles.
Program
Continuation:
Clear alarm with the RESET key. Restart part program
66000 Channel %1 block %2:
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: References: The current alarm text, the error description and the remedial measures for the user cycle
alarms can be found in the Programming Guide of the machine manufacturer.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Refer to the manual on user cycles.
Program
Continuation:
Clear alarm with the RESET key. Restart part program
67000 Channel %1 block %2:
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: References: The current alarm text, the error description and the remedial measures for the user cycle
alarms can be found in the Programming Guide of the machine manufacturer.
Reaction: Alarm display.
Remedy: Refer to the manual on user cycles.
Program
Continuation:
Clear alarm with the Delete key or NC START.