EasyManua.ls Logo

Siemens SINUMERIK 810D - Page 621

Siemens SINUMERIK 810D
880 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
HMI alarms
11/2006 Overview of Alarms
2-621
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
101018 Read-in possible only in active PLC status !
Definitions: The current PLC status mode is not active, e.g. if the softkey "Change" was pressed.
Remedy: Switch the PLC status to active.
101019 Not possible to initialize the HMI internal PLC status!
Definitions: --
Remedy: --
101020 Not possible to backup the HMI internal PLC status!
Definitions: --
Remedy: --
101100 No access rights !
Definitions: The access level set is too low to open the selected window.
Remedy: Enter a higher password.
101110 Error on overall reset
Definitions: --
Remedy: --
101111 No axes configured !
Definitions: Due to an incomplete start-up, the image "Service axis" or "Axis machine data" cannot be selected.
Remedy: Complete start-up.
101112 No drives configured !
Definitions: Due to an incomplete start-up, the image "Service drive" cannot be selected.
Remedy: Complete start-up.
101113 No channels configured !
Definitions: Due to an incomplete start-up, the image "Channel machine data" cannot be selected.
Remedy: Complete start-up.
101114 No MSD configured !
Definitions: Due to an incomplete start-up or missing MSD drives, the image "MSD machine data" cannot be
selected.
Remedy: --
101115 No FDD configured !
Definitions: Due to an incomplete start-up or missing FDD/SLM drives, the image "FDD machine data" cannot be
selected.
Remedy: --
101130 Error return value undefined: %1 %2
Parameters: %1 = --
%2 = --
Definitions: A function was called up in the start-up area that then, for unknown reasons, could not be executed.
Remedy: When provided with the issued digits, the service may be able to help.

Other manuals for Siemens SINUMERIK 810D

Related product manuals