Siemens SINUMERIK 810D Diagnostic Manual

Overview of Alarms 11/2006
SIMODRIVE alarms
2-800
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
380001 Profibus-DP: startup error, reason %1 parameter %2 %3 %4.
Parameters: %1 = Cause of the error
%2 = Parameter 1
%3 = Parameter 2
%4 = Parameter 3
Definitions: An error occurred during startup of the PROFIBUS DP master.
Overview: Cause of the error, Par 1, Par 2, Par 3:
- 01 = DPM version, DPM version, DPA version, --
- 02 = DPM ramp-up timeout, DPM actual value status, DPM setpoint value status, --
- 03 = DPM ramp-up status, DPM actual value status, DPM setpoint value status, DPM error code
- 04 = DPM ramp-up error, DPM actual value status, DPM setpoint value status, DPM error code
- 05 = DPM-PLL sync error, --, --, --
- 07 = alarm queue too long, Actual number, Setpoint number, --
- 08 = unknown client, Client ID, --, --
- 09 = Client version, Client ID, Client version, DPA version
- 10 = too many clients, Client number, Max. number of clients, --
- 11 = log.basic address used several times; bus no.; slot no.; log.basic address --
- 20 = PB slave address used several times, slave address --
- 21 = PB slave address unknown, slave address, --
- 22 = Erroneous configuration telegram, slave address, error code, --
- 23 = OMI incompatible (data), Version drive, Version CDA --
- 24 = OMI incompatible (driver), Version drive, Version CDA --
- 25 = CPI initialization failed, error code
- 26 = reserved
- 27 = reserved
- 28 = reserved
- 29 = reserviert
- Digit position 1000 of the error cause = number of the affected bus
Clients are the following components of the control system that use the PROFIBUS DP:
Client ID = 1: PLC
Client ID = 2: NCK
The following can be causes:
- Error in contents of SDB-Type-2000
- Corruption of parts of system program
- Hardware defect on NC component
Reaction: Channel not ready.
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Remedy for 1-11
1. Check the control project (especially SDB-Type-2000); check MD 11240 and reload it when using
a user-specific SDB.
2. If the error still occurs, back up data and restart the control with the standard values as per the as-
delivered condition.
3. In case of correct ramp-up, gradually reload the user data.
4. If the error still occurs during ramp-up with standard values, reboot the system from the PC card or
execute a software update.
5. If the error still occurs, replace the hardware.
Remedy for 20-21
1. Check/correct the PROFIBUS addresses of the connected slaves.
Remedy for 22
See SINAMICS warning 1903 for a description of the meaning behind the error codes.
1. Control the SDB
- Control type and length of the telegram
- Match slot assignment with P978
2. Evaluate the drive alarms/warnings
Remedy for 23-24
1. Software replacement required
Remedy for 25
1. Change the telegram type
2. Reduce the number of slots
3. Reduce the number of slaves

Siemens SINUMERIK 810D Specifications

General

Brand	Siemens
Model	SINUMERIK 810D
Category	Control Unit
Language	English