Overview of Alarms 11/2006
SIMODRIVE alarms
2-808
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
380502 PROFIBUS DP: bus %1, slave %2 configuration changed
Parameters: %1 = Bus number
%2 = Slave address
Definitions: The PB bus configuration has changed.
Causes:
- Initial start-up
- New PB slave recognized on the bus
Reaction: Interface signals are set.
Alarm display.
Remedy: In order to operate the bus with the new configuration, an additional restart will be required.
Program
Continuation:
Switch control OFF - ON.
380503 PROFIBUS DP: bus %1 configuration changed
Parameters: %1 = Bus number
Definitions: A new SDB2000 with a modified configuration was provided.
The new settings will be activated only at the next ramp-up of PROFIBUS.
Reaction: Interface signals are set.
Alarm display.
Remedy: In order to operate the bus with the new configuration, an additional restart will be required.
Program
Continuation:
Switch control OFF - ON.
To Next Page
Loading...
Need help?
General
