3-831
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
List of Action Numbers 3
The following list describes the actions stated in the alarm texts under "Action %.."
according to their numbers.
No. 1
No. 2
No. 3
No. 4
Explanation Run Init phase (tasks are initialized after power on).
Cause -
Remedy -
Explanation Perform reset (VDI signal: Reset, mode group reset or after power on).
Cause -
Remedy -
Explanation Activate Reset Init blocks (VDI signal: Reset).
Cause -
Remedy -
Explanation Perform reset, end of program has been detected (NC block with M30).
Cause -
Remedy -
To Next Page
Loading...
