EasyManuals Logo

Siemens SINUMERIK 810D Diagnostic Manual

Siemens SINUMERIK 810D
880 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #858 background imageLoading...
Page #858 background image
Error Codes of Alarm 300500 11/2006
4-858
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
Extension 2
-
Explanation The limits of the internal processor hardware stack or of software stack in the data mem-
ory have been violated. The cause is probably a hardware error on the control module.
Remedy
Reload drive software. Replace the control module.
Error code 0011H
Error text
NMI due to watchdog
Extension 1 Opcode address
Extension 2
-
Explanation The watchdog on the control module has timed out. The cause is a hardware error in the
time base on the control module.
Remedy
Replace the control module.
Error code 0012H
Error text NMI due to clock cycle failure
Extension 1 -
Extension 2
-
Explanation The NC basic cycle, which is generated on the NC and transferred to the drive via the
drive bus cable, has failed.
Possible causes: NCK reset, EMC interference, NC hardware error, cable break on the
drive bus, hardware error on the control module.
Remedy Check the drive bus cable and cable connections, perform remedial measures (check
shielding or ground connection). Replace the NC hardware, replace the control module.
Error code 0013H
Error text
Clock cycle came too early
Extension 1 -
Extension 2
-
Explanation The NC basic cycle which is generated on the NC and transferred to the drive via the
drive bus cable has supplied a pulse which does not match the clock timing.
Possible causes: EMC interference on drive bus, NC hardware error, hardware error on
the control module.
Remedy Check the drive bus cable and cable connections, perform remedial measures (check
shielding or ground connection). Replace the NC hardware, replace the control module.

Other manuals for Siemens SINUMERIK 810D

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SINUMERIK 810D and is the answer not in the manual?

Siemens SINUMERIK 810D Specifications

General IconGeneral
BrandSiemens
ModelSINUMERIK 810D
CategoryControl Unit
LanguageEnglish

Related product manuals