Siemens Sinumerik 840 sl

Tables
15.1 List of statements
Job planning
Programming Manual, 03/2006 Edition, 6FC5398-2BP10-1BA0
15-33
SYNRW
The variable is read and
written synchronously, i.e., at
execution time
(synchronous read-write)
SYNW The variable is written
synchronously, i.e., at
execution time
(synchronous write)
T Call tool
(only change if specified in
machine data; otherwise M6
command necessary)
1 ... 32
000
Call using T-no.:
or with tool
identifier:
e.g., T3 or T=3
e.g., T="DRILL"
TAN Tangent (trigon. function) Real
TANG Determine tangent for the follow-up from
both specified leading axes
TANGOF Tangent follow-up mode OFF
TANGON Tangent follow-up mode ON
TCARR Request toolholder (number
"m")
Integer m=0: deselect
active toolholder
TCARR=1
TCOABS
1
Determine tool length components from the
orientation of the current toolholder
Necessary after
reset, e.g.,
through
m 42
TCOFR Determine tool length components from the
orientation of the active frame
Manual setting m 42
TCOFRX Determine tool orientation of an active
frame during tool selection, tool points in X
direction
Tool
perpendicular to
inclined surface
m 42
TCOFRY Determine tool orientation of an active
frame during tool selection, tool points in Y
direction
Tool
perpendicular to
inclined surface
m 42
TCOFRZ Determine tool orientation of an active
frame during tool selection, tool points in Z
direction
Tool
perpendicular to
inclined surface
m 42
TILT
5
Tilt angle Real TILT=Value m
THETA Angle of rotation THETA is always
vertical to the
current tool
orientation
THETA=Value
THETA=AC
THETA=IC
Polynomial for THETA
PO[THT]=(…)
s
TMOF Deselect tool monitoring T-no. required
only when the
tool with this
number is not
active
TMOF (T no.)
TMON Activate tool monitoring T No. = 0:
Deactivate
monitoring for all
tools
TMON (T no.)