EasyManuals Logo

Siemens SINUMERIK 840D Diagnostics Guide

Siemens SINUMERIK 840D
714 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #689 background imageLoading...
Page #689 background image
1-689
ï›™ Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
03.04 1 Alarms
1.5 System reactions on alarms
Names COMPBLOCKWITHREORG
Effect Block preparation has detected an error, which can be rectified by modifying the program.
Reorganization follows program modification.
- Compensation block is also reorganized.
Names
COMPENSATIONBLOCK
Effect Block preparation has detected an error, which can be rectified by modifying the program.
- Compensation block
Names
FOLLOWUP
Effect Axes are tracked.
- NC switches to follow-up mode.
Names
INTERPRETER STOP
Effect Program execution is aborted after all the prepared blocks (interpolator buffer) have been
processed.
- Interpreter stop
Names
LOCALREACTION
Effect - Local alarm reaction
Names
NOALARMREACTION
Effect - No alarm reaction
Names
NOREADY | NCKREACTIONVIEW
Effect NCK ready off: Active rapid deceleration (i.e., with maximum braking current) of all drives
Clearing of servo enable for all NC axes Release of NC ready relay.
- NC not ready.
Names
NOREADY | BAGREACTIONVIEW
Effect Mode group ready off: Active rapid deceleration (i.e., with maximum braking current) of
the drives in this mode group Clearing of servo enable for the NC axes concerned.
- Mode group not ready.
Names
NOREADY
Effect Channel ready off: Active rapid deceleration (i.e., with maximum braking current) of the
drives in this channel Clearing of servo enable for the NC axes concerned.
- Channel not ready.
Names
NONCSTART
Effect It is not possible to start a program in this channel.
- NC start disable in this channel
Names
NOREFMARK
Effect The axes in this channel need to be rereferenced.
- Rereference the axes in this channel.

Other manuals for Siemens SINUMERIK 840D

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SINUMERIK 840D and is the answer not in the manual?

Siemens SINUMERIK 840D Specifications

General IconGeneral
SeriesSINUMERIK 840D
AxesUp to 31
ChannelsUp to 10
Operating SystemWindows-based
Power Supply24 V DC
Control Unit TypeCNC
InterfaceEthernet, PROFIBUS
DisplayTFT color display
InterpolationSpline
PLCIntegrated PLC
Data StorageCompactFlash, USB

Related product manuals