Siemens SINUMERIK 840D - Page 585

NCK alarms
11/2006 Overview of Alarms
2-585
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
62910 Channel %1 block %2: Error while calculating the contour orientation
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions:
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: --
Program
Continuation:
Clear alarm with the RESET key. Restart part program
62911 Channel %1 block %2: Error on overwriting target
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions:
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: --
Program
Continuation:
Clear alarm with the RESET key. Restart part program
62912 Channel %1 block %2: Plane cannot be specified here
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions:
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: --
Program
Continuation:
Clear alarm with the RESET key. Restart part program
62913 Channel %1 block %2: Inch/metric indication not allowed
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions:
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: --
Program
Continuation:
Clear alarm with the RESET key. Restart part program