EasyManuals Logo

Siemens SINUMERIK 840D Diagnostic Manual

Siemens SINUMERIK 840D
880 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #624 background imageLoading...
Page #624 background image
Overview of Alarms 11/2006
HMI alarms
2-624
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
101153 Erroneous HMI NCK communication %1 %2
Parameters: %1 = Error class
%2 = Error code
Definitions: In the start-up area the softkey "Calculate controller data", for example, was pressed.
An unspecific error message is sent from the NCK or drive as acknowledgement for this function call.
By using the two hexadecimal values (error class, error code), the start-up engineer can perform an
error diagnostics.
Remedy: --
101154 PI service refused
Definitions: The current status of the NKC/drive does not permit the function that was selected.
Remedy: See the Installation and Start-up Guide.
101155 Path %1 does not exist
Parameters: %1 = Path
Definitions: During a file function, e.g.saving boot files, an attempt was made to access
a non-existent path.
Remedy: Switch the control OFF/ON or see the Installation and Start-up Guide.
101156 Function impermissible
Definitions: The selected function is impermissible.
Remedy: See the Installation and Start-up Guide.
101157 File %1 does not exist
Parameters: %1 = File name
Definitions: In the start-up area the softkey "delete boot files", for example, was pressed, although no boot files
are yet available.
Remedy: --
101158 Function in current operating mode not allowed
Definitions: The drive's current status does not permit this function.
Remedy: --
101159 Remote block in incorrect state
Definitions: The drive's current status does not permit this function.
Remedy: --
101160 Date and time of PLC set
Definitions: In the PLC status, the time or date was changed.
Remedy: --
101161 The drive is not in cyclic mode!
Definitions: The start-up is not completely carried out, therefore, the function "Calculate motor data" cannot be
selected.
Remedy: --
101162 MDx134/MDx400
MOTOR_NOMINAL_FREQUENCY/MOTOR_RATED_SPEED illeg.
Definitions: --
Remedy: --

Other manuals for Siemens SINUMERIK 840D

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SINUMERIK 840D and is the answer not in the manual?

Siemens SINUMERIK 840D Specifications

General IconGeneral
SeriesSINUMERIK 840D
AxesUp to 31
ChannelsUp to 10
Operating SystemWindows-based
Power Supply24 V DC
Control Unit TypeCNC
InterfaceEthernet, PROFIBUS
DisplayTFT color display
InterpolationSpline
PLCIntegrated PLC
Data StorageCompactFlash, USB

Related product manuals