Siemens SINUMERIK 840D Diagnostic Manual

List of Action Numbers 11/2006
3-846
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
No. 80
No. 81
No. 82
No. 83
No. 84
No. 85
Explanation Selection of an NC block (PI command)
Cause -
Remedy -
Explanation Disable the NC program which is currently being processed for editing (PI command)
Cause -
Remedy -
Explanation Start a program in the TEACH IN submode (VDI signal: NC Start).
Cause See Nos. 33 and 5
Remedy -
Explanation Start a program in the TEACH IN submode (VDI signal: NC Start).
Cause See Nos. 33 and 5
Remedy -
Explanation Reorganize block processing
Cause -
Remedy -
Explanation Activate an "ASUB" user interrupt in a manual mode (VDI signal: ASUB interface, digital-
analog interface).
Cause See No. 10
Remedy -

Siemens SINUMERIK 840D Specifications

General

Series	SINUMERIK 840D
Axes	Up to 31
Channels	Up to 10
Operating System	Windows-based
Power Supply	24 V DC
Control Unit Type	CNC
Interface	Ethernet, PROFIBUS
Display	TFT color display
Interpolation	Spline
PLC	Integrated PLC
Data Storage	CompactFlash, USB