Siemens SINUMERIK 840D - Page 139

840D/828D SINUMERIK Operate Page 9
B510
B510
Notes
Program for the washer 1
N10 G18 G54 G64 LIMS=4000
N20 ;.Without scaling
N30 LBL14:
N40 G00 X200 Z300
N50 T1 ; Roughing tool
N60 G96 S160 F0.2 M4 D1
N70 G00 X42 Z0.1 M8
N80 G01 X-1.6
N90 Z3
N100 G00 G42 X14 Z2
N110 G01 Z0
N120 X38 RND=1.5
N130 Z-8
N140 X42
N150 G00 G40 X200 Z300
N160 T10 ; Core drill Dm. 16
N170 G97 S2500 F0.15 M4 D1
N180 G00 X0 Z3 M8
N190 G01 Z-7
N200 G00 Z3
N210 G00 X200 Z300
N220 T3 ; Parting tool 3.1 wide
N230 G96 S140 F0.1 M4 D2 ; Right hand cutting edge activated
N240 G00 X40 Z-4
N250 G01 X14
N260 G00 X40
N270 ATRANS Z-8 ; Additive offset
N280 REPEAT LBL14 P2 ; Repeat
N290 TRANS ; Clearance of the Frames
N300 G00 X200 Z300
N310 M30
Offset of the coordinate system
Section 6