This document was produced for training purposes.
Siemens assumes no responsibility for its contents.
840D/828D SINUMERIK Operate
840D/828D SINUMERIK Operate
Basic operations
B518
Aim of the module:
In this module you learn about the screen organization of the display panel of the SINUMERIK Oper-
ate, as well as the the basic operation of the control using softkeys and buttons.
Description of the module:
This module describes the relevant parts of the main screen of the operation terminal with the help of
a basic figure.
In addition to the topic above, this module covers the selection of parameters with respect to units
(mm/inch) used and the usage of the calculator within the input masks.
1 Brief description
To Next Page
Loading...
