Siemens SINUMERIK 840D - Page 23

840D/828D SINUMERIK Operate Page 21
B500
B500
Notes
Milling Section 5
Unit
Selection
(Thread-
milling)
Selection of table values:
M3, M10, etc. (ISO metric)
W3/4"; etc. (Whitworth BSW)
G3/4"; etc. (Whitworth BSP)
1" - 8 UNC; etc. (UNC)
AZ
Depth of roughing
(only for finishing)
mm
β1
End-angle to X-axis Degrees
β2
Opening angle of the circle Degrees
Machining
(Planar-/
thread-
milling)
Roughing
Finishing
Machining
(Rectangular
/round
spigot)
(path milling)
Roughing
Finishing
Chamfering
Machining
(Rectangular
/circ. pocket)
(Longitudinal
/circ. slot)
(polygon)
(spigot
milling)
Roughing
Finishing
Finishing of the edge
Chamfering