840D/828D SINUMERIK Operate
Notes
Section 5
Program control
5.2 Vertical softkey bar
Display area Description
Because there is no other selection possible the
softkey “General” is active by default.
By pressing the VSK 8 “Back“ yo can switch back to
the “Program control” window.
5.3 Controlling the program run
1. In the operating mode “MDA” select the HSK 4
„Progr. cntrl.“.
The “Program control” window opens.
2. Select the desired program control (see Section 5.1
in this module).
3. Press the VSK 8 “Back” to switch back to the main
screen of the SINUMERIC Operate in “MDA”-
operating mode.
To Next Page
