This document was produced for training purposes.
Siemens assumes no responsibility for its contents.
840D/828D SINUMERIK Operate
840D/828D SINUMERIK Operate
Operating mode “AUTO”
B522
1 Brief description
Aim of the module:
Working through this module you become familiar with the operating mode “AUTO” in the operating
area “MACHINE”.
Description of the module:
This module describes, how to overstore technological parameters (for example, auxiliary
functions, axis feed, spindle speed, programmable instructions, etc.) for a program run in the
main memory of the NCK.
It is described among other things, how the execution of a program can be stopped at a specific part
of the program run with the function “Program control“ (programmed stop).
The differences between the two block search modes (with or without calculation) will be explained in
detail as well as the function “Simultaneous recording”.
A more detailed description of the function “Program correction” can be found in the modules
B601and B605 “Basics of programming”.
The handwheel assignmet and the function “Settings” complete this module.
To Next Page
