840D/828D SINUMERIK Operate
Notes
4.2 Controlling the program run
1. In the operating mode “AUTO“ and the operating
area “Machine” press the HSK 1.4 “Prog. cntrl.“.
The “Program control” window opens and shows a
list of program control options.
2. Select the desired program control. (see section 4.1
in this module).
3. Press the VSK 8 “Back” to go back to the main
screen of the Sinumerik Operate in the operating
mode “AUTO” and operating area “Machine”.
Section 4
Program control
To Next Page
