Siemens SINUMERIK 840D - Page 32

B500
B500 Page 30 840D/828D SINUMERIK Operate
Notes
Milling Section 5
Unit
R
(Rectangular
pocket/
spigot)
Corner radius mm
R
(circular slot)
Radius of the circular slot mm
R
(Milling)
Radius of the circle mm
RP
(Centring)
Retraction plane mm
Radius cor-
rection
(Path milling)
Left
(machining to the left of the contour)
Right
(machining to the right of the contour)
OFF
Direction
In continuous machining direction
to the right
to the top
In changing machining direction
meandering left/right
meandering up/down
S
Spindle speed rev/min
Stop-
Position
Input of the spindle position in degrees
Starting
point
(Pocket
milling)
Manually preset starting point
Automatic starting point calculation
SW
(polygon)
Spanner size A/F
T
Input of the tool
(Name or place number)