Siemens SINUMERIK 840D - Page 327

This document was produced for training purposes.
Siemens assumes no responsibility for its contents.
840D/828D SINUMERIK Operate
840D/828D SINUMERIK Operate
Operating area “Program”
B524
1 Brief description
Aim of the module:
In this module you learn about the structure of the program editor in the operating area “Program“.
Description of the module:
The SINUMERIK Operate provides the opportunity to create NC-programs, and also to integrate
comfortably cycles into the program.
These programs are created as G-code programs as per DIN 66025, however, elements of the high
level language can be included.