Siemens SINUMERIK 840D - Page 34

B500
B500 Page 32 840D/828D SINUMERIK Operate
Notes
Milling
Section 5
Unit
W
(Rectangular
pocket)
Width of the pocket mm
W
(Rectangular
spigot)
Width of the spigot mm
W
(Longitudinal
/circular slot)
Width of the slot mm
W
(Engraving)
Character height mm
W1
(Rectangular
pocket)
Width of the pre-machining
(only for further machining)
mm
W1
(Rectangular
spigot)
Width of the raw material spigot (Important for
the determination of the approach location)
mm
X0
(Rectangular
/circular
pocket)
(Rectangular
spigot)
Reference point X
(only for single location)
mm
X0
(Planar
milling)
Reference point 1 X mm
X1
(Planar
milling)
Reference point 2 X (abs) or reference point 2X
referred to X0 )inc)
mm
X1
(Rectangular
/circular
spigot)
Spigot depth (abs) or depth referred to Z0 or X0
(inc)
mm
X1
(Longitudinal
slot)
Slot depth (abs) or depth referred to Z0 or X0
(inc)
mm
XFS
Plunging depth of tool tip (abs or inc)
(only for chamfering)
Machining face mantle C/Y
mm
XM
(Engraving)
Centre point X (abs) or centre point polar length
(only for curved alignment)
mm
or
Degrees
XS
(Pocket
milling)
Starting point X
(only for manual starting point preset)