840D/828D SINUMERIK Operate
Notes
Section 4
Displaying messages
PLC and part program messages may be issued during machining.
Messages provide information with regard to a certain behaviour of the cy-
cles and with regard to the progress of machining and are usually kept be-
yond a machining step or until the end of the cycle.
Date and time
- Date and time of the occurrence of the message
Number
- Message number only displayed for PLC messages.
Text
- Message text in short words.
Note:
These message will not interrupt the program execution.
4.1 Selecting the function “Messages
By pressing the HSK 1.2 “Messages” the
“Messages”-window opens, showing PLC and part
program messages during machining.
To Next Page
