Siemens SINUMERIK 840D - Page 375

This document was produced for training purposes.
Siemens assumes no responsibility for its contents.
840D/828D SINUMERIK Operate
840D/828D SINUMERIK Operate
Basics of the programming with the
programGUIDE
1 Brief description
Objective of the module:
Working with this module you will learn the concept of the G code programming with the ShopTurn
programGUIDE.
Description of the module:
This module explains the general program structure of a ShopTurn G code program, programmed
with the programGUIDE. Furthermore the functions of the “Editor“ are described, as well as the func-
tions “Various “, “Simulation“ and “NC-Selection“.
B605