This document was produced for training purposes.
Siemens assumes no responsibility for its contents.
840D/828D SINUMERIK Operate
840D/828D SINUMERIK Operate
Drilling
1 Brief description
Objective of the module:
Working through this module you become familiar with the technology “Drilling” by programming two
G code programs with the programGUIDE in ShopTurn.
Description of the module:
This module explains the programming of a simple drilling example with the programGUIDE in Shop-
Turn, as well as well as the programming of a more complex workpiece by means of drilling cycles
and position patterns.
B611
To Next Page
