This document was produced for training purposes.
Siemens assumes no responsibility for its contents.
840D/828D SINUMERIK Operate
840D/828D SINUMERIK Operate
Milling
1 Brief description
Objective of the module:
Working through this module you become familiar with the technology “Milling” by programming two
G code programs with the programGUIDE in ShopTurn.
Description of the module:
This module explains the programming of a simple milling example (multi-edged spigot) with the pro-
gramGUIDE in ShopTurn, as well as well as the programming of a more complex workpiece
(rectangular pocket).
B618
To Next Page
