This document was produced for training purposes.
Siemens assumes no responsibility for its contents.
840D/828D SINUMERIK Operate
840D/828D SINUMERIK Operate
Contour turning
1 Brief description
Objective of the module:
Working through this module you become familiar with the technology „Contour turning“ by program-
ming two G code programs with the programGUIDE in ShopTurn.
Description of the module:
This module explains the programming of a contour turning machining with the programGUIDE in
ShopTurn, as well as well as the programming of a more complex workpiece by means of contour
descriptions, stock removal- and residual cutting cycles.
B626
To Next Page
