Siemens SINUMERIK 840D - Page 446

B626
B626 Page 14 840D/828D SINUMERIK Operate
Notes
The following program code is inserted into the pro-
gram:
N180 CYCLE952("ROUGHING",,
"REST_ROUGHING",2301311,0.3,0,0,1.9,0.1,0.1,0.
2,0.2,0.1,0,3,0,0,,,,,2,2,,,0,1,,0,12,1110110)
12. Program the following G code commands:
N190 G0 X200 Z200
13. Insert a tool into the program.
Press the VSK 1.1 “Select tool“.
The tool list window opens.
Select the tool “BUTTON_TOOL_8” by using the
blue cursor key on the keyboard.
Press the VSK 1.1 “To program”.
The following program line is inserted into the pro-
gram:
N200 T="BUTTON_TOOL_8"
Optionally you can program the tool by hand.
14. Program the following G code commands:
N210 M6
N220 S240 M4 F0.25
15. Insert a contour call “CYCLE62” into the program.
Press now the VSK 1 “Contour”.
The vertical softkey bar for creating or calling up a
contour opens.
Press the VSK 2 “Contour call” to open the input
mask for the call up of a contour.
16. Enter the following contour name into the parameter
mask:
Confirm your input by pressing the VSK 8 “Accept”.
The following line is inserted into the program:
N230 CYCLE62("SPIGOT_BLANK",1,,)
Note:
The contour “SPIGOT_BLANK” you called up here,
will be created in section 31.
Section 3
Complex programming example