Siemens SINUMERIK 840D - Page 47

This document was produced for training purposes.
Siemens assumes no responsibility for its contents.
840D/828D SINUMERIK Operate Page 1
B502
B502
840D/828D SINUMERIK Operate
Geometry Basics
B502
1 Brief description
Aim of the module:
In this module you learn to understand the programming planes and also to specify points in a DIN
conforming coordinate system.
Description of the module:
This module explains the assignment of the axis and plane descriptions to the coordinate system of
the machine and also teaches the determination of points in relation to the work space.