Siemens SINUMERIK 840Di - Page 533

NCK alarms
11/2006 Overview of Alarms
2-533
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
61281 Channel %1 block %2: starting point of machining outside retraction
planes
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The starting point of machining is outside the retraction planes.
Alarm triggered by following cycle: F_SP_RP.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Adjust the retraction planes.
Program
Continuation:
Clear alarm with the RESET key. Restart part program
61282 Channel %1 block %2: end point of machining outside retraction planes
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The end point of machining is outside the retraction planes.
Alarm triggered by following cycle: F_SP_RP.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Adjust the retraction planes.
Program
Continuation:
Clear alarm with the RESET key. Restart part program
61283 Channel %1 block %2: direct approach not possible, as tool change
required
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: After block search a position is to be reached by direct approach, but a tool change is required before.
Alarm triggered by following cycle: F_TFS.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: First execute a manual tool change, then restart the block search.
Program
Continuation:
Clear alarm with the RESET key. Restart part program