Siemens SINUMERIK 840Di - Page 546

Overview of Alarms 11/2006
NCK alarms
2-546
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
61369 Channel %1 block %2: Position of corner not clearly definable, check
parameter (_SETV[0...7])
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm is triggerd by the following cycles: CYCLE961.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Define P1 and P2 or P3 and P4 in a way that the intersection of the straights determined by these
points is outside the sections formed by P1 and P2 or P3 and P4.
Program
Continuation:
Clear alarm with the RESET key. Restart part program
61370 Channel %1 block %2: _PROTVAL[0] -_PROTVAL[5] do not have any
entries
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm is triggerd by the following cycles: CYCLE105.
Remedy: Enter values in _PROTVAL[0...5].
61371 Channel %1 block %2: Product of column width and number of columns
exceeds 200 characters per line
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm is triggerd by the following cycles: CYCLE105.
Remedy: Reduce the column width (_PROTFORM[4]) or number of columns (_PROTVAL[2...5]).
61372 Channel %1 block %2: selected meas.variant requires SPOS-capable
spindle
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: Alarm can be triggered by following measuring cycles: all measuring cycles.
Remedy: Change measuring variant or check machine equipment.
61373 Channel %1 block %2: Mono-directional probe requires SPOS-capable
spindle
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: Alarm can be triggered by following measuring cycles: all measuring cycles.
Remedy: Check machine equipment.
61401 Channel %1 block %2: Probe not switching, traversing path limitation
through software limit position
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm is triggerd by the following cycles: CYCLE961, CYCLE971, CYCLE976, CYCLE977,
CYCLE978, CYCLE998
The position defined by a setpoint value cannot be reached, as the software limit position has been
exceeded.
Remedy: Check specified setpoint value.