Siemens SINUMERIK 840Di - Page 556

Overview of Alarms 11/2006
NCK alarms
2-556
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
61530 Channel %1 block %2: Default longitudinal position incorrect
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm can be triggered by the following grinding cycles: CYCLE420
Remedy: Check longitudinal position parameter
61531 Channel %1 block %2: Longitudinal position not registered in Z
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm can be triggered by the following grinding cycles: CYCLE420
Remedy: Increase infeed path parameter
61532 Channel %1 block %2: Value for _LAGE is incorrect
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm can be triggered by the following grinding cycle: CYCLE414
Remedy: Correct parameter content for _LAGE
61533 Channel %1 block %2: No length L1 entered under D...
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm can be triggered by the following grinding cycles: CYCLE416, CYCLE420
Remedy: Enter length L1 in the tool offset D of the grinding wheel
61540 Channel %1 block %2: Incorrect D number / dresser D field active
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm can be triggered by the following grinding cycles: CYCLE401, CYCLE402, CYCLE403,
CYCLE443
Remedy: A tool D number must be programmed that is < _GC_DNUM
61541 Channel %1 block %2: Incorrect grinding wheel type entered
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm can be triggered by the following grinding cycles: CYCLE432, CYCLE434, CYCLE435,
CYCLE436, CYCLE438, CYCLE439, CYCLE444, CYCLE447
Remedy: Select a valid grinding wheel type in tool management
61542 Channel %1 block %2: Incorrect grinding wheel reference point selected
when selecting the dresser coordinate system
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm can be triggered by the following grinding cycles: CYCLE435, CYCLE441, CYCLE447
Remedy: A tool D number must be programmed that is < _GC_DNUM
61543 Channel %1 block %2: Incorrect dresser selected when selecting the
dresser coordinate system
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm can be triggered by the following grinding cycles: CYCLE402, CYCLE435, CYCLE442,
CYCLE447
Remedy: A dresser number >0 and <4 must be selected