Siemens SINUMERIK 840Di - Page 838

List of Action Numbers 11/2006
3-838
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
No. 34
No. 35
No. 36
No. 37
No. 38
No. 39
Explanation Stop the active processing (VDI signal: NC Stop)
Cause -
Remedy -
Explanation Start machine data processing (INI file is already in the NCK)
(PI command).
Cause -
Remedy -
Explanation Start machine-data processing (INI file is located externally, e.g., on MMC)
(PI command).
Cause -
Remedy -
Explanation Stop because of mode group single block. VDI signal, single type A (only executable
blocks), after stop in another channel in this mode group.
Cause -
Remedy -
Explanation Stop because of mode group single block. VDI signal, single type B (any blocks), after
stop at end of block in another channel in this mode group.
Cause -
Remedy -
Explanation Stop because end of overstore buffer "_N_OSTOREXX_SYF" has been reached.
Cause -
Remedy -