Siemens sinumerik fm-nc - Page 65

3
03.96
3.5 Handheld programming unit
3-65
 Siemens AG 2000 All Rights Reserved
SINUMERIK 840D Installation and Start-Up Guide (IAD) – 04.00 Edition
The following parameter settings must be made for the MCP and HPU operating
components in FB1:
MCPNum:=1 (one MCP)
MCP1In:=P#E0.0 (MCP input signals)
MCP1Out:=P#A0.0 (MCP output signals)
MCPStatRec:=P#Q12.0 (status double word)
MPCBusAdr:= 6,
HPU:=1 (one HPU)
HPUIn:=P#F16.0 (HPU input signals)
HPUOut:=P#F16.0 (HPU output signals)
HPUStatRec:=P#F24.0 (status double word)
HPUBusAdr:= 11,
Parameterization
of basic PLC
program FB1
3 Settin
g
s, MPI / OPI
08.97