To Next PageTo Next Page
Need help?Do you have a question about the Siemens SINUMERIK 810DE powerline and is the answer not in the manual?
General| Type | CNC Controller |
|---|---|
| Input Voltage | 24 V DC |
| Control loops | Position, Speed, Current |
| PLC | Integrated |
| Protection Class | IP20 |
| Interfaces | RS-232, Ethernet, PROFIBUS DP |
| Programming Language | DIN/ISO 66025 |
| Interpolation | Linear, circular |
| Communication | Profibus, Ethernet |
| Hard Drive | CompactFlash |
| Operating System | Proprietary |
| Control Technology | Digital CNC |
| Number of axes | Up to 6 axes |
Details components of a fully equipped SINUMERIK 810D.
Tests and conditions for fault-free operation.
Demands on DC power supplies and requirements.
Tools and steps for assembling the SINUMERIK 810D.
Overview of system components.
Overview of module interfaces.
Assignment of measuring systems and motor connection.
Installation of axis expansion plug-in units.
Features, connection, and technical data of the single I/O module.
Procedure for replacing the CCU module battery.
